Description
Product details
Port: Common Port Do not connect the charger or load to P -. It is an invalid port)
It must be charged for a period of time to activate for the first time.
BMS parameter table
❖Charging voltage
10S x 4.2V
❖Discharge current
15A
Peak current
35A
❖Charging current
10A
❖Charging cut-off
Voltage detection: 4.25V ± 0.03V
Voltage release: 4.15V ± 0.03V
Detection delay: 1000mS
❖Discharge cut-off
Voltage detection: 2.8V ± 0.1V
Voltage release: 3.0V ± 0.1V
Detection delay: 1000mS
❖Cell balance
Turn on voltage: NA
Turn off voltage: NA
Balance current: NA
❖Overcurrent cut-off
Voltage detection: NA
Detection delay: 350mS
Release method: disconnect load or charging
❖Short circuit cut-off
External load short circuit
Detection delay: 300uS
Release method: disconnect load or charging
❖Self-consumption
Work power consumption:<40uA
❖Internal resistance:
<15mΩ
❖The scope of work:
-40℃/ +80℃
Port: Common Port Do not connect the charger or load to P -. It is an invalid port)
It must be charged for a period of time to activate for the first time.
Warm tips
1. Please use it be careful when installing to avoid short circuit.
2. Do not remove or replace the components of the protection board by yourself.
3. Lithium battery protection board with different voltages cannot be mixed. For example, lithium ion BMS cannot be used for Lifepo4.
4. The charge and discharge current cannot exceed the rated value.
5. Please do not change the circuit board .
6. Please use the protective boad within the specified working temperature range and ensure a good heat dissipation environment around the protective board.
7. Design parameters and use conditions must be observed during use because improper use will damage the circuit.
Reviews
There are no reviews yet.